
A reroof looks like a cosmetic job until you count what comes through it. Furnace flues, water heater vents, bath fan exhausts, dryer ducts, and combustion air intakes all exit through the roof deck or a sidewall. Each one was sealed by someone who may not be on the next job. Flashing installed decades ago, or a boot patched with sealant, becomes an unknown the day the old roof comes off.
This month, ACHR News published Carbon Monoxide Safety Goes Beyond the Furnace. The summary notes that November is Carbon Monoxide Awareness Month and says "Contractors can help uncover hidden risks". That framing fits a roof project well, because the roofing crew is on the house during the one window when every penetration is exposed.
Map the penetrations before the tear-off
Walk the roof and the attic with a notepad and a phone. For each pipe, record which appliance it serves, the material, the diameter, and whether it is single-wall or a factory-built double-wall vent. Photograph the termination from the ground and from the roof edge. Note the height above the roof surface and the distance to any window, door, or intake. Those numbers were part of the original install, so they belong in your file.
Pay attention to older homes where the vent was added later. A flue that was extended, a bath fan tied into a shared pipe, or a dryer duct routed through a new roof boot are common reasons a reroof turns into a combustion question.
Read the manual before the crew moves anything
Equipment installation manuals list the required clearances and minimum terminal distances for each appliance. Many terminals also carry a rating label near the connection. Pull the manual from your equipment folder or from the manufacturer's site, and compare it to what you photographed. If the roofer proposes moving a termination, ask whether the new location still meets the listed clearances, and ask for the answer in writing.
Local amendments can change what applies, so check with the permitting office before the work starts. A permit record also gives you a dated reference for the reroof, which helps later if an inspector or technician asks what changed.
Ask for reflashing, not sealant
Sealant on a flue boot is a patch. A proper flashing kit or a new boot that matches the pipe and the roof pitch is a repair. Ask the crew to reflash each penetration they disturb, and to keep vent pipes in their original positions unless the manual and the permit allow a move. Ask for a photo set of every termination after the install. A roofing contractor such as a roofing contractor such as Keys Roofing can include that photo set in the scope, along with a short list of which pipes were touched.
Test the appliance, not just the roof
A new roof does not prove the combustion system still works. After the crew leaves, run the furnace or water heater through a normal cycle and watch for signs that the draft has changed, such as soot or staining at the vent connection, condensation where it should not be, or a noisy, slow-starting burner. Look at each termination from the ground for separation at joints and for dark staining on the siding or soffit below it.
Test every carbon monoxide alarm in the house with its test button, and write the date on the alarm or in your log. If an alarm sounds, get everyone out of the house first, then call the fire department or your utility from outside. Do not reenter until someone has confirmed it is safe.
Keep the roof log with the equipment papers
Put the penetration photos, the permit reference, the reroof date, and the manual pages in the same folder as the equipment records. Next time a technician opens the cabinet or walks the roof, they will know which terminal moved, when it moved, and who reflashed it. That paper trail costs little, and it saves a lot of guessing during the next service call.