
Any rooftop unit, and many ground units with a roof-mounted chase, depends on a set of penetrations that most homeowners never see up close. There is the supply and return opening through a curb, the refrigerant line set that exits through a wall or roof jack, the condensate drain, the gas line, and the electrical whip. Each one is a place where water can enter if the flashing, sleeve, or sealant was chosen poorly or installed without allowing for movement. When the ceiling stains under a unit, the first question is usually which trade made the hole.
That question is getting harder to answer cleanly as larger firms widen their scope. ACHR News reports that MasTec is set to acquire mechanical contractor Murphy in a $1.25 billion deal, and its summary describes the move as "an expansion into mechanical contracting and HVAC service operations serving complex facilities." Whatever the deal means for the companies involved, the lesson for a homeowner stays the same: one contract name on the invoice may cover work that was split among several crews.
Ask Who Set Each Penetration
Before the next storm season, walk the roof edge with the installer's paperwork or your own photos and sort each opening by owner. A typical record shows the mechanical crew setting the curb and running the line set, a roofing crew installing the membrane around it, and an electrician bringing the whip through a separate jack. If nobody can name the flashing installer, you have a gap, and gaps are where repair arguments start.
Ask three direct questions. Who sealed the curb to the roof deck and to the membrane? What material was used at the line set sleeve, and does it allow for the expansion and contraction of the copper? Does the roofing warranty cover the mechanical penetrations, or does it exclude them? The answers may point to a different company than the one that services the compressor, and that split is common.
When the membrane around a curb looks lifted, cracked, or ponded, a roofing contractor such as Keys Roofing is the right call for the flashing, while the HVAC technician handles anything inside the cabinet or the refrigerant circuit. Keep those visits separate on paper so the roofer is not blamed for a condensate problem and the HVAC crew is not blamed for a membrane seam.
Build the Penetration Log
A penetration log is a one-page record you keep with the unit's manuals. For each opening, note the date, the trade that worked on it, the sealant or flashing product named on the invoice, and its location measured from a fixed reference such as the nearest roof edge or a parapet corner. Take two photos per opening, one wide and one close, from the same spot each visit so changes stand out. Mark any opening where you have seen staining on the ceiling below, because a leak that shows up inside often started several feet away on the roof.
Pair the log with the unit's service notes. If a technician reports a condensate line that was reattached, record the date and whether the float switch was tested. If the drain pan showed moisture, log the day it was found. Read together, the two records show whether a roof leak and a drain problem are one issue or two.
Access and Safety Limits
Do not walk on a membrane to check a curb unless the roofer confirms it is rated for foot traffic and you have proper footwear and fall protection. Most homeowners can do the visual check from a stable ground position with binoculars or a phone camera on a pole. Look for gaps at the curb corners, a sleeve that has pulled away from the line set, and sealant that has cracked into a hairline pattern. Record what you see and call the right trade rather than improvising a patch that could complicate a warranty claim.
Attic checks still matter. If the penetration sits above a closet, a return plenum, or a ceiling run, a flashlight and a moisture meter can confirm whether the decking is wet before the stain appears below. Mark the spot on the attic floor with a tape line so the next inspection starts in the same place.
What to Take Away
Roof penetrations are a shared scope even when one company holds the contract. Name the owner of each opening, keep the log, and separate the roof repair from the mechanical repair. That habit costs little, and it turns a vague leak into a question with a specific answer.
Further reading: a roofing contractor such as Keys Roofing.