Heating & Cooling Doc No. HCD-depressurization-carbon-monoxide-draft-test

Depressurization Is a Carbon Monoxide Path: Test the Draft Before the Exhaust Fan Runs

Bath fans, range hoods, and dryers can pull combustion gases back into a house, so test the draft at the hood with every exhaust running before the cold nights arrive.

By The Dispatch Bench Desk: Heating & Cooling
Home Comfort Dispatch

ACHR News published a piece titled Carbon Monoxide Safety Goes Beyond the Furnace, and its summary frames the story around "Carbon Monoxide Awareness Month." The headline points at a useful habit for homeowners. A furnace or water heater is only part of the picture. The other part is whether the house lets those appliances vent cleanly, and that depends on air pressure as much as on the burner.

Pressure Is the Hidden Variable

Many older appliances, including naturally drafted furnaces and atmospheric water heaters, rely on the house sitting close to neutral pressure relative to the outdoors. Hot flue gas rises because it is buoyant, and the chimney pulls it up. Now add a bath fan, a kitchen range hood, a clothes dryer, and in some houses a fireplace. Each one exhausts air from the house. If the home does not receive enough makeup air to replace what leaves, the mechanical room drops below outdoor pressure, and the draft at the appliance can reverse.

A tighter envelope makes this more likely, not less. Air sealing is good practice for comfort and energy use, but it changes the pressure balance. If you seal the attic, the rim joists, or the penetrations in the basement, retest the combustion side afterward instead of assuming the old result still holds.

Set Up the Test

Pick a cold evening, when the stack effect is strongest and the problem is most likely to show. Run the appliances the way the household normally runs them. Turn on the bath fan, put the range hood on high, and start the dryer if it is in use. Note every exhaust you ran, because the result only means something if you can repeat it later with the same setup.

If you own a digital manometer, use it to read the pressure difference between the mechanical room and outdoors. Log one reading with the exhausts off and another with them on. You are looking for the swing between the two readings, not a single number in isolation. A manometer also shows whether a door, a return grille, or a basement window is changing the balance during the test.

Read the Smoke

The low-tech version uses a smoke pencil or an incense stick. With the burner running and the exhausts off, hold the smoke near the draft hood, the opening between the appliance and the vent connector. Healthy draft pulls the smoke into the hood and up toward the flue. Then turn on the exhausts and repeat the check. If the smoke leans out of the hood, or drifts into the room at the hood opening, you have spillage.

Test with the appliance firing, not just the fan running, because spillage often shows only under combustion. Repeat the check on another cold night as well, since outdoor temperature and wind change the result. A single clean reading on a mild afternoon proves very little.

Check the Path Out

If the test shows spillage, look at the vent path itself. A cracked connector, a loose joint at the draft hood, a flue that has lost its slope, or a blocked cap will all change how the gas leaves the house. Anything above the roof line needs a look from someone who works on steep surfaces safely. A roofing contractor such as Keys Roofing can check the roof jack, the flashing, and the cap from a safe position, while the combustion side stays with a qualified heating technician.

What the Alarm Does Not Do

A carbon monoxide detector warns you after the gas has built up. It does not tell you why the gas is there, and it does not tell you which appliance or exhaust is responsible. Pressure and smoke tests are how you find the cause. If a detector sounds, leave the house, call the emergency number from outside, and do not go back in until the responding authorities say it is safe. Do not try to diagnose a live combustion problem by running appliances inside the house.

The practical routine is simple. Test with every exhaust running, read the smoke at the draft hood, write down what you saw, and have the vent path checked whenever the result is not clean. Awareness month is a useful reminder, but the cold nights are what actually do the testing.

Further reading: a roofing contractor such as Keys Roofing.

← More from Heating & Cooling