
November is Carbon Monoxide Awareness Month, which is a practical reason to stop treating the alarm on the hallway ceiling as finished business. ACHR News' piece is titled Carbon Monoxide Safety Goes Beyond the Furnace, and its summary says: "Contractors can help uncover hidden risks and protect homeowners." That line is written for trade professionals, but the homeowner's half of the job is simple. You need a floor plan, a pencil, and an honest look at where each alarm sits compared with where people sleep and where combustion happens.
Start with a sketch, not a shopping list
Draw each level of the house on graph paper or a printed floor plan. Mark every carbon monoxide alarm you own, including the ones in basements, bonus rooms, and any spare unit still sitting in a box. Then mark each sleeping room, each bathroom, and the route from the bedrooms to the nearest exit. An alarm that cannot be heard from behind a closed bedroom door is not doing much for the person inside. Check the manufacturer's placement instructions for each model and compare them with your local code, because spacing and mounting rules differ by product and jurisdiction. Treat this as a survey, not a guess.
Mark every combustion source on the same drawing
Next, add the fuel-burning equipment: the furnace or boiler, the water heater, the range, a gas dryer, and any fireplace or stove. Note whether the home has an attached garage, because a vehicle left running or a heater used in a closed space changes what the air in the house contains. Ask whether the garage has its own alarm, and whether a unit near the shared wall or connecting door fits your layout. Do not decide from memory that a garage detector is optional or required. Read the equipment manuals and the local rule, then ask the technician who services your heating equipment to confirm the placement.
Look for what blocks the device
A detector hidden behind a curtain, stacked boxes, or a shelf is not a finished installation. Check the face and sides of each unit for paint, dust, or insulation that may have been pushed against it during a project. Look at whether a supply register or return blows air steadily across the alarm, since moving air can affect how a sensor reads its surroundings. Note any unit within reach of a kitchen appliance or sitting in a steamy bathroom, and decide with the manufacturer's instructions whether it belongs there. Write down what you find, even if the answer is that everything looks fine.
Check the roofline and the vent path
Combustion gases do not stop at the furnace room door. A flue that terminates badly, a vent cap that has shifted, or flashing that looks loose where a flue passes through the roof can all change how those gases leave the building. You do not need to climb the roof to notice trouble. From the ground, look for a cap sitting crooked, a flue that is discolored at a joint, or staining on the wall beneath the termination. If something looks off, a roofing contractor such as Keys Roofing can inspect the roof penetration, and you should tell the heating technician what you saw so they can check the combustion side of the same path.
Put the map where the household will find it
Once the drawing is done, label each alarm with its location and its install or replacement date. Keep a copy near the furnace room door and another with the house paperwork. Walk through the plan with everyone who lives there, including anyone who sleeps in a room you had not considered. If an alarm sounds, the household needs one agreed response, and the map helps everyone understand which part of the house to check first. If anyone feels unwell while the heating equipment runs, get outside to fresh air and call your local emergency number. Do not wait to see whether the feeling passes.