
In a supermarket, every time a cooler door or entry opens, warm and humid air moves into a space that refrigeration is working to keep cold. ACHR News explains how open doors affect supermarket refrigeration, and its summary frames air curtains as a way to "control doorway infiltration" while easing heat and moisture loads. The store problem is much larger than a house, but the physics that drives it is the same one you deal with at your garage-to-house door.
Pressure Moves Air, Not Just Gaps
A door can look sealed and still leak. Air moves from higher pressure to lower pressure through any available path, and the path does not have to be a visible crack. Your house is often slightly negative or positive compared to the garage, depending on what is running. A kitchen range hood, bath fan, clothes dryer, or furnace air handler can pull or push air across that door even when the weatherstrip looks fine.
An air curtain works on this same principle. It places a moving barrier across the opening that resists the push of pressure differences. A house does not need that hardware, but it does need to know which way the air is being pushed and how hard.
Measure the Difference Before You Seal
A digital differential pressure gauge with two tubes is the right tool. Place one tube on the house side of the door and the other on the garage side, using a small access point such as a threshold gap or a hole you can plug afterward. Close the door and all exterior openings, then record the reading with everything off.
Next, run one device at a time: the bath fan, the kitchen hood, the dryer, and the air handler on fan mode. Write down how each one moves the number. Expect small readings, often just a few pascals, so keep the gauge steady and note whether the reading holds or drifts. Repeat the sequence in the same order on the same day so the results can be compared.
If there is a gas water heater, a furnace, or any other fuel-burning appliance in the garage or venting through it, treat this as a safety check, not a fun experiment. Pressure swings can change how exhaust draws, so have a qualified technician check the venting before you change anything. Test the carbon monoxide alarm near that equipment as well.
Seal the Path, Then Reduce the Push
Fix things in order. First, close the leak path with a door sweep, a tight threshold seal, and foam or caulk around wire and pipe penetrations at the frame. Then address the push. If a return grille sits in the garage or near that door, move or rebalance the return. Run exhaust fans only as long as needed. If the house is very tight, ask about makeup air, since a sealed house can starve a fan and change how the whole system behaves.
After each change, retest with the same fan sequence. A single reading tells you where things stand that day. A sequence of readings tells you whether the change helped.
Keep a One-Page Log
Use one sheet with the date, outdoor temperature, door position, which fans were running, the pressure reading for each state, and short notes about drafts or cold spots at the door. Keep the same format every time. Over a few weeks, the log shows whether the garage door is a steady problem or only a problem when the dryer and hood run together.
If an older parent lives in the house while you handle the work from somewhere else, the checks can be shared. A family member can walk through and report a cold draft or a stuffy room, and you can arrange non-medical in-home support for older adults in St. Louis for daily presence. The readings, the repairs, and the decisions about the equipment still belong to the owner and the technician.